MIL-PRF-55371B(CR)
4.4 Conformance inspection. The contractor shall perform the inspections specified in
4.4.1 through 4.4.5. This does not relieve the contractor of the responsibility for performing any
additional inspections necessary to control the quality of the product and to assure compliance
with all specification requirements.
4.4.1 Group A inspection. Units presented for inspection shall be inspected for
conformance to the criteria specified in Table III. Lots in which samples exhibit any failures
shall be screened for that failure prior to being subjected to Group B inspection.
TABLE III. Group A inspection.
Inspection
Requirement
Test
paragraph
paragraph
Visual and Mechanical (workmanship)
3.7
4.7
Case
3.5.3
4.7
Holding strap
3.5.5
4.7
Ribbon
3.5.7
4.7
Handle
3.5.11
4.7
Operation
3.5
4.5.1
Case, Vinyl cover
3.5.4
4.7
4.4.1.1 Order of inspection within Group A. Group A inspection shall be performed in
any order satisfactory to the Government.
4.4.2 Group B inspection. This inspection shall consist of the inspections listed in Table
IV and shall be performed on lots that have passed Group A inspection. Lots in which samples
exhibit any failures shall be screened for that failure prior to the units within the lot being
subjected to Group C inspection.
TABLE IV. Group B inspection.
Inspection
Requirement
Test
paragraph
paragraph
Accuracy
3.5.12
4.5.2
Finger Ring
3.5.7.3
4.5.7
Holding strength at reel
3.5.10
4.5.6
4.4.2.1 Order of inspection within Group B. Group B inspection shall be performed in any
order.
4.4.3 Group C inspection. Group C inspection shall be performed on units that have
passed Group A and B inspections, and shall consist of the inspection specified in Table V.
Sampling shall be in accordance with 4.4.3.1.
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business