MIL-PRF-49176B(CR)
HANDBOOKS
DEPARTMENT OF DEFENSE
MIL-HDBK-454
- Standard General Requirements For Electronic
Equipment
(Unless otherwise indicated, copies of the above specifications, standards, and handbooks are
available from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4d,
Philadelphia, PA 19111-5094.)
2.2.2 Other Government documents, drawings, and publications. The following other
Government documents, drawings, and publications form a part of this specification to the extent
specified herein. Drawings listed below are to be used to ensure accurate interface of the item
produced under this performance specification with existing hardware.
DRAWINGS
USA CECOM
SM-D-773912
- Schematic Diagram, Bias Regulator Assembly
SM-C-773541
- Connector, Receptacle, Electrical
SM-C-773501
- Connector, Receptacle, Electrical
(Copies of specifications, standards, drawings, and publications required by contractors in
connection with specific procurement functions should be obtained from the procuring activity or
as directed by the contracting officer.)
2.3 Non-Government publications. The following document(s) form a part of this
specification to the extent specified herein. Unless otherwise specified, the issues of the
documents which are DoD adopted are those listed in the issue of the DoDISS cited in the
solicitation. Unless otherwise specified, the issues of documents not listed in the DoDISS are the
issues of the documents cited in the solicitation (see 6.2).
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI/IPC S-815A
- General Requirements For Soldering Electronic
Interconnections.
(Application for copies should be addressed to the American National Standards Institute,
1430 Broadway, New York, N.Y. 10018).
AMERICAN SOCIETY FOR QUALITY CONTROL
ANSI/ASQC Z 1.4
- Sampling Procedures And Tables For Inspection By
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business