MIL-PRF-49168C(CR)
2.3 Non-Government publications. The following documents form a part of this document
to the extent specified herein. Unless otherwise specified, the issues of the documents which are
DoD adopted are those listed in the issue of the DoDISS cited in the solicitation. Unless
otherwise specified, the issues of documents not listed in the DoDISS are the issues of the
documents cited in the solicitation (see 6.2).
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
ASTM E 122-89
- Sample Size to Estimate a Measure of Quality
for a Lot or Process
(Application for copies should be addressed to the American Society for Testing and
Materials, 1916 Race Street, Philadelphia, PA 19103-1187).
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI/IPC S-815A
- General Requirements for Soldering Electronic
Inter-Connections
(Application for copies should be addressed to the American National Standards Institute
Inc., 1430 Broadway, N.Y., N.Y. 10018).
AMERICAN SOCIETY FOR QUALITY CONTROL (ASQC)
ANSI/ASQC Z 1.4
- Sampling Procedures; Tables for Inspection by
Attributes
(Application for copies should be addressed to the American society for Quality Control,
Inc. P.O. box 3005, 611 East Wisconsin Avenue, Milwaukee, WI, 53202).
2.4 Order of precedence. In the event of a conflict between the text of this document and
the references cited herein, the text of this document takes precedence. Nothing in this
document, however, supersedes applicable laws and regulations unless a specific exemption has
been obtained.
3. REQUIREMENTS
3.1 First article. Where specified in the contract (see 6.2), the contractor shall furnish first
article units for inspection (see 4.2).
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business