MIL-PRF-49316A(CR)
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
ASTM E 122-89
- Sample Size to Estimate a Measure of Quality
for a Lot or Process; choice of
(Application for copies should be addressed to the American Society for Testing and
Materials, 1916 Race Street, Philadelphia, PA 19103-1187).
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI/IPC-S-815A
- General Requirements for Soldering Electronic
Interconnections
(Application for copies should be addressed to the American National Standards Institute,
1430 Broadway, N.Y., N.Y. 10018).
2.4 Order of precedence. In the event of a conflict between the text of this document and
the references cited herein, the text of this document takes precedence. Nothing in this
document, however, supersedes applicable laws and regulations unless a specific exemption has
been obtained.
3. REQUIREMENTS
3.1 First article. When specified in the contract (see 6.2.d), the contractor shall furnish
first article units for inspection (see 4.2).
3.2 Materials. The contractor shall select the materials, but the materials and parts used
shall be fully capable of meeting all of the operational and environmental requirements specified
herein. The materials specified in the applicable drawings are recommended, but are not
mandatory. Selection criteria of the class, grade or type part shall be that the material will be
able to perform its intended function when it is assembled. Verification of the supplier meeting
the overall performance requirements shall be the governing acceptance standard. Recovered
materials shall be used to the maximum extent possible.
3.3 Description. The Test Set is a self-contained test set designed to check the Aviator's
Night Vision Imaging System (ANVIS), AN/AVS-6(V)1 and AN/AVS-6(V)2 for proper
operation. A darkened, sheltered area is required for proper use. A collimation attachment and
a diopter scope are special tools which comprise an attachment kit for use with the Test Set.
The Test Set also checks proper operation of the Night Vision Goggles (NVG) AN/PVS-5 (A,
B, C) and AN/PVS-7 (A, B) as specified herein.
3.4 Design. The Test Set shall meet the form, fit, function and interface requirements as
specified herein.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business